- ok, what's the command you use to set up the COMM port (bit, speed,parity,...) under Linux?
- I used input with 8 characters/bytes, but still if one device is offline, then it will stop at that
step and will not run the rest of lines in the program!So, I would like to use the command Input with
time like 3 sec maximam so if there is no response from the device, then it just wait for 3 seconds then
goes to the next step.
- What's the command to check the port stauts if it is opened or not?
Thanks a lot, and sorry for bothering you with my many questions